Hardware: ESP32-C3-DevKitM-1

Display: Waveshare 2inch LCD 240*320 resolution with ST7789 driver (CN) (EN)

IDE: Arduino IDE 2.3.4

Arduino Board and Library: esp32 by Espressif Systems (rev 3.0.7) and TFT_eSPI (rev 2.5.43) and Adafruit ST7735 and ST7789 Library

Issue: I could display successfully with Adafruit ST7735 and ST7789 Library example codes, which provide my hardware is all good. However, I cannot run TFT_eSPI example projects such as <Read_User_Setup> project. Below is the <User_Setup.h> file I used. The pinout should be correct because I used the exactly same pinout to run with "Adafruit ST7735 and ST7789 Library" example project successfully.

#define USER_SETUP_INFO "User_Setup"
#define ST7789_DRIVER
#define TFT_RGB_ORDER TFT_RGB
#define TFT_WIDTH  240
#define TFT_HEIGHT 320

#define TFT_MOSI 7    // SPI Q. also called MOSI    
#define TFT_SCLK 6    // SPI clock 
#define TFT_CS   10   // Chip select control pin
#define TFT_DC   8    // Data Command control pin
#define TFT_RST  -1   // Reset pin (could connect to RST pin)

#define LOAD_GLCD   // Font 1. Original Adafruit 8 pixel font needs ~1820 bytes in FLASH
#define LOAD_FONT2  // Font 2. Small 16 pixel high font, needs ~3534 bytes in FLASH, 96 characters
#define LOAD_FONT4  // Font 4. Medium 26 pixel high font, needs ~5848 bytes in FLASH, 96 characters
#define LOAD_FONT6  // Font 6. Large 48 pixel font, needs ~2666 bytes in FLASH, only characters 1234567890:-.apm
#define LOAD_FONT7  // Font 7. 7 segment 48 pixel font, needs ~2438 bytes in FLASH, only characters 1234567890:-.
#define LOAD_FONT8  // Font 8. Large 75 pixel font needs ~3256 bytes in FLASH, only characters 1234567890:-.
//#define LOAD_FONT8N // Font 8. Alternative to Font 8 above, slightly narrower, so 3 digits fit a 160 pixel TFT
#define LOAD_GFXFF  // FreeFonts. Include access to the 48 Adafruit_GFX free fonts FF1 to FF48 and custom fonts

#define SMOOTH_FONT

#define SPI_FREQUENCY  27000000
#define SPI_READ_FREQUENCY  20000000
#define USE_HSPI_PORT

From serial port monitor, I could see the MCU seems to reboot automatically.

Below is my Arduino IDE setting.